Nine precautions for the operation of tube filling and sealing machine

Tube filling and sealing machine is an automated filling machine, so at any time in the use of a variety of negligence may encounter different problems, the following small talk about the operation of the hose filling and sealing machine nine precautions.

1, before using the tube filling and sealing machine, please clean up the surrounding environment. In particular, automated equipment can not be placed next to the normal operation of the equipment to prevent the debris and dangerous goods.

2、The parts of the tube filling and sealing machine are finely machined by CNC lathe, and the parts fit properly with the size, do not put on the parts that are not suitable for the performance of the machine or modify them at will, otherwise accidents will happen.

3、The operators of the tube filling and sealing machine are specially trained, so the operators' work clothes should be as sharp as possible. Special attention: the sleeves of the work clothes must be tied well and cannot be opened.

4、After all parts of the hose filling and sealing machine are adjusted, slowly rotate the machine to check whether the equipment is working normally and whether there are any vibrations or abnormalities.

5、The main drive system of the machine is located at the bottom of the machine, which is closed by the stainless steel door with lock. When adjusting the load, it must be opened and adjusted by a person (operator or maintenance technician). Before starting the machine again, be sure to confirm that all doors are in good condition.

Tube filling and sealing machine

6、The tube filling and sealing machine is closed by the transparent plexiglass door above the desktop. No one is allowed to open it when the machine is started normally.

7、In case of emergency, please press the red emergency stop button to troubleshoot in time. If you need to restart, be sure to confirm that the fault has been completely eliminated. Reset the emergency stop button and restart the main machine.

8、The tube filling and sealing machine should be operated by trained and qualified personnel according to the regulations. Do not allow others to operate the machine at will, otherwise it will cause personal injury and machine damage.

9、Before each filling, carry out 1-2 minutes idle test to check the rotation of all machine parts, work smoothly, run smoothly, no abnormal noise, adjusting device works normally, each instrumentation works reliably.