Labeling machine work when the labeling position is not stable how to

  　We use automatic labeling machine stickers, sometimes encounter labeling position is unstable slightly offset, what is the reason for it, how to deal with? The labeling machine work labeling position is not stable how to do?

　　1, the pressure belt device may not be tight, resulting in loose label belt, the electric eye detection is not allowed. Tighten the label to solve.

　　2, may be traction mechanism slippage or is not pressed, resulting in the smooth take away the backing paper. Tighten the traction mechanism to solve, too tight will pull the label distorted, in order to be able to pull the normal backing paper is better. (Usually if the pull out of the backing paper when wrinkled, then it should be when the pressure is too tight)

　　3, the shape of the object to be attached is not the same or positioning is not one to one. Control the quality of the product.

　　4, the object to be affixed should be placed parallel to the direction of the label (pay attention to whether the product in the labeling process is out of position, the left side of the support bar than the right side of the appropriate raise a little)

　　5, the object to be labeled in the labeling station should ensure smooth rotation (note that it can not touch the peeling plate), the object is too light, the labeling rod should be put down, pressing the object to be labeled

　　6, in the double label state, the labeling machine out of a single label (1) out of a single label, the workpiece has been rotating, because there is no set the second label delay, the machine is waiting for the second label labeling signal state. (2) The workpiece stops after a single label is issued. It is because there is signal interference in the label measuring electric eye (reset the electric eye) or the delay control is abnormal (click twice to tap 2 and then click twice to tap 1.