Brief description of the labeling machine in the use of the process to pay attention to maintenance from time to time

Brief description of the labeling machine in the use of the process to pay attention to maintenance from time to time

In the usual use of automatic labeling machine in the process of how to use the correct, timely detection and resolution of common problems labeling machine? Here we will make a simple introduction, labeling machine operators can be based on different situations to find the problem, timely processing, to avoid labeling misalignment. Under normal circumstances, the center of the label brush is right on the label and symmetrical on both sides, the label brush perpendicular to the surface of the container, the center line of the label box, the center axis of the label station and label paper tangent, the center axis of the label plate three points into a line, adjust the label plate and label paper tangent (0 distance), and then move the label box closer to 1mm ~ 2mm can be, the label paper in the label box and the gap between the two sides of the pressure bar should be between 0.8mm ~ 1mm, the gap is too large to cause the label paper in the label The gap is too large to cause the paper to shift in the label box, the appearance of oblique label, the gap is too small will cause the push label is not smooth. Between the label plate and the rubber roller is only mutual contact without any pressure, the gap is too large, too much glue on the label plate, resulting in dumping glue, the gap is too small, the contact is too tight, will squeeze the glue away, the label plate half without glue. These are some basic knowledge of the use of labeling machine, according to the product characteristics of its appropriate adjustment, so that the labeling effect is better.